Enviracaire EWM-220 Operations Instructions download pdf (Page 9)

STORAGE TIPS

If you do not plan to use your humidier for an extended period of time, such as

during the summer months, it is important that you follow these instructions to help

prevent problems from developing in the unit.

1. Clean your humidier as instructed in the section titled, “Cleaning and

Maintenance”.

2. Make sure all water is emptied from the tanks and the hot and cold water

reservoirs.

3. Dry your unit thoroughly.

4. Leave the tank caps o to expose the tanks to air.

5. Pack your humidier in its original carton and store it in a cool, dry place.

SERVICE

DO NOT attempt to repair this humidier yourself. For repairs covered under the

warranty, contact Kaz Incorporated by telephone or mail for a Return Authorization

Number.

TROUBLESHOOTING

TROUBLE POSSIBLE CAUSES SOLUTION

Unit does not mist Unit is not plugged in Plug in unit

Power failure Check circuit breaker

Water tanks empty Remove and rell

Power switch not turned on Push switch to ON

Unit not reset after relling tanks Reposition water tanks

Water tank not properly Reposition water tanks

located on base unit

Humidity level set is achieved Turn Relative Humidity

Control to higher setting

Only one tank empties Move unit to level surface.

Raise end with full tank.

Water leaks from unit Tank cap or tank cap Tighten cap.

gasket is missing or Replace tank cap

improperly positioned or reposition cap gasket.

Moist air output low Mineral buildup in hot water Clean unit as per

reservoir instructions.

Rell indicator light on Water level is below water Rell water tanks

level oat and mount tanks on base

Water level oat Clean oat per

is covered with lm cleaning instructions

Mineral buildup in hot water Clean unit per

reservoir cleaning instructions

EWM-220_OM.indd 9 3/26/07 2:53:57 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Enviracaire EWM-220 Operations Instructions Page 9